Difference between revisions of "Retract Pump and Cylinder Rebuild"
m |
|||
| (5 intermediate revisions by 2 users not shown) | |||
| Line 10: | Line 10: | ||
Linked below are his diagrams, explanations, and instructions for rebuilding the hydraulic pump and cylinders.<br/> | Linked below are his diagrams, explanations, and instructions for rebuilding the hydraulic pump and cylinders.<br/> | ||
| − | + | Schematic [[File:Gear_pump_schematics_and_details_(Lancair_documentation).pdf]]<br/> | |
| − | Schematic | + | Rebuilding [[File:Rebuilding_Lancair_Hydraulic_Cylinders.pdf]]<br/> |
| − | [[File:Gear_pump_schematics_and_details_(Lancair_documentation).pdf]][[ | + | |
| − | [[ | + | The parts list for '''replacing the main and nose gear cylinder seals''' can be found on the |
| + | [[Landing_Gear_Cylinder_Rebuild]] page.<br/> | ||
| + | <br/> | ||
| + | [[Image:Hyraulic Schematic.jpg|right|400px]]<br/> | ||
Latest revision as of 12:46, 7 July 2016
The RG hydraulic pump rebuild kits seem strangely difficult to locate. There is some good info in the Lancair community. They use the same pump/cylinder system that Velocities do. According to their experts, the only non-standard part in the pump rebuild kit is the poppet valve, so you only need a rebuild kit if the poppet valve is leaking. Usually, you just need these standard O-rings from McMaster:
013-90, Spool Seal (013N90)
014-90, Check Valve Body seal (014N90)
908-70, Hex Plug Seal
908 Durometer 90
For more info, see Lancair builder Chris Zavatson's site: http://www.N91CZ.net
Linked below are his diagrams, explanations, and instructions for rebuilding the hydraulic pump and cylinders.
Schematic File:Gear pump schematics and details (Lancair documentation).pdf
Rebuilding File:Rebuilding Lancair Hydraulic Cylinders.pdf
The parts list for replacing the main and nose gear cylinder seals can be found on the
Landing_Gear_Cylinder_Rebuild page.
