Controls

This section is for builder's Tips and Tricks for Controls, as well as one-off modifications.

Control Stick Enhancement

This tip for improving the way the standard center control stick mounting/support again comes from Jim Agnew. Jim_agnew_2 at yahoo dot com

While flying with Sam I commented on the stick play (side to side) and he said that it was caused by the limited support in the lateral direction caused by the two round pieces of tubing having almost no bearing surface. He mentioned the new velocity saddle type mount and said that he had made some microglass bearings to provide more support. This intrigued me so back at the hanger I grabbed a 1 1/4” piece of 6061-T6 aluminum rod and chucked it up in the lathe. I trued the surface and the exposed end and lathe drilled a ¼” axial hole in the rod. Next I used the mill to precision mill a ¾” hole at right angles to the axial hole and centered on the rod.

You now have a rod with a ¾” hole thru it and a 90 degree intersecting hole down the center of the rod. Placing the rod back in the lathe I lathe drilled the ¼” axial hole to 3/8” on one side of the ¾” intersecting hole. The bushing in the aluminum torque tube is this size so one side must be 3/8” & the other ¼”. Next I faced the end of the rod until the metal at the axial hole was only .040 thick measuring out from the ¾” hole. At this point I cut the rod on the inboard side of the ¾” hole and reversed the piece in the lathe. Face the new end to the same .040 thickness and then you cut the rod in half thru the center of the ¾” hole. You now have two round aluminum washers with a ¾” half round grove and a hole (one ¼” & one 3/8”) perpendicular to the grove and centered in it.

Next I polished the flat sides on 400 grit emery paper to a very smooth finish. I then made a round bearing washer to fit the flat sides out of .002 brass shim stock and with a ¼” center hole. Almost done, I removed the through bolt from the stick and placed the 3/8” drilled washer on the bolt with the ¾” with grove against the torque tube If made correctly this “saddle” will be a very tight fit and actually stick to the torque tube. Next coat the brass washer on both sides with NeverSez (the same stuff you use on spark plug threads) and place over the bolt. Next comes the ¼” drilled washer with the groove facing the stick. Install the stick on the bolt and tighten firmly to seat the saddles. Then back off the tension slowly testing the elevator action to make sure you don’t have too much friction. When you are happy with the action install the stick locknut and lock the bolt. You will find that the elevator action is butter smooth and there is no aileron side play other than the bending of the torque tube that is slight. You will find that aileron reaction is much faster. There is far less strain on the torque tube and pivot bolt and the expected life of the piece is probably well beyond the aircraft by a factor of ten.

• 

  Bottom of bushings showing the working face and brass washer. They don't look it in the picture but they are posished to a 400 finish. They are aluminum and the gold color is false and due to the lighting.

• 

  Bushings Installed

• 

  Side View

• 

  Working Position

• 

  Bushings from top with brass washer bearing

Side Sticks

N77LY Side Sticks

Go to the Side Sticks page to see aircraft modified to use side stick controls rather than the standard center stick.

Side Sticks

Yokes

N2059U Flight Yokes

Go to the Yokes page to see SUV and other aircraft fitted with flight yokes.

Yokes