Difference between revisions of "Elevator Center Bearing"
(Created page with " If you look at Andy Millins site you'll see photos of how mine and his and others I've worked on are done. I use ball bearings that permit the inner .375 ID pivot compared to...") |
|||
| Line 1: | Line 1: | ||
| − | + | I use ball bearings that permit the inner .375 ID pivot compared to the outer OD as the canard flexes in flight under load and not bind. It works well and is very smooth. | |
| − | |||
At the same time replace the front bearing in the console. There cheap and have play in them that gets annoying on landing. It starts clicking and makes the elevator system feel sloppy! Mainly during landings due to the small correction in pitch during a landing. | At the same time replace the front bearing in the console. There cheap and have play in them that gets annoying on landing. It starts clicking and makes the elevator system feel sloppy! Mainly during landings due to the small correction in pitch during a landing. | ||
| Line 10: | Line 9: | ||
V8 Velocity RG | V8 Velocity RG | ||
| + | The plans have an arm with an aluminum busing where the elevators join. The arm has been removed and a new arm has been potted in place, made from 1/4" AL. Notice the flanges that engaged the bushing on the elevator torque tube have also been removed. | ||
| + | If you are interested in the mod, here is the parts list: | ||
| − | + | 2 Bearings #KSP6A/MS27645-6A | |
| + | 1 3/8 Bolt AN6-21A | ||
| + | 1 Nut AN365-624A | ||
| + | 10 washers/thick AN960-616 | ||
[[File:elevator_bearing_upgrade.jpg]] | [[File:elevator_bearing_upgrade.jpg]] | ||
[[File:elevator_bearing_installed.jpg]] | [[File:elevator_bearing_installed.jpg]] | ||
Revision as of 12:32, 13 April 2011
I use ball bearings that permit the inner .375 ID pivot compared to the outer OD as the canard flexes in flight under load and not bind. It works well and is very smooth.
At the same time replace the front bearing in the console. There cheap and have play in them that gets annoying on landing. It starts clicking and makes the elevator system feel sloppy! Mainly during landings due to the small correction in pitch during a landing.
If you have any questions feel free to email me at bmulrooney@comcast.net
Bill Mulrooney N427VA V8 Velocity RG
The plans have an arm with an aluminum busing where the elevators join. The arm has been removed and a new arm has been potted in place, made from 1/4" AL. Notice the flanges that engaged the bushing on the elevator torque tube have also been removed.
If you are interested in the mod, here is the parts list:
2 Bearings #KSP6A/MS27645-6A
1 3/8 Bolt AN6-21A
1 Nut AN365-624A
10 washers/thick AN960-616
